SMALL FEEDER- SPINNER MOTOR- 6Vdc- BIRDS/FISH/DEER

Description

THESE MOTORS WERE DESIGNED FOR A LEADING FEEDER MANUFACTURER WHO CANCELED THEIR ORDER IN ORDER TO USE CHEAPER UNITS.  THEY ARE 100% GOOD AND WERE DESIGNED BY A LEADING DC MOTOR SUPPLIER IN THE USA.
THIS MOTOR IS A FLAT SIDED UNIT WITH A SHAFT DIAMETER OF 0.078 INCHES AND 4 HOLE MOUNTING ON A 0.63 INCH BOLT CIRCLE. THE SHAFT LENGTH IS 0.47 INCHES.  THE MOTOR IS .95 INCHES ACROSS THE FLAT AND 1.2 INCHES ON THE DIAMETER. THE TOTAL LENGTH IS 1.65 INCHES.  THIS MOTOR HAS EXCEPTIONAL TORQUE AND A SPEED OF 7000 RPM AT 6VDC.  IN ADDITION, THE NON DRIVE END HAS A SELF ALIGNING BEARING VERSUS A CYLINDRICAL AND A 5-BAR COMMUTATOR FOR EXCELLENT LIFE AND LOW NOISE.
8 INCH LEADS WILL BE SOLDERED ON THE TERMINALS AND MOUNTING SCREWS ARE INCLUDED.
THIS MOTOR IS DESIGNED FOR SMALLER FEEDERS VERSUS OUR LARGER UNIT LISTED.   YOU CAN IDENTIFY THE RIGHT SIZE BY MEASURING THE SHAFT DIAMETER IN YOUR FEEDER.  SMALL CHANGES IN THE MOUNTING MAY NECESSITATE DRILLING A NEW HOLE PATTERN TO MATCH AT LEAST TWO OF THE HOLE CENTERS.  IF YOU HAVE ANY QUESTIONS ASK- BEFORE YOU BUY.
THIS LISTING IS FOR (2) MOTORS-  WITH 8 inch LEADWIRES AND 4 SCREWS.
PROCEDURE FOR DETERMINING IF THEY FIT YOUR FEEDER:  The primary way to see if they will fit your feeder is to look at the dimensions of the overall unit, the shaft dimensions (diameter and length) and mounting hole pattern.  This motor may work from a performance standpoint but makes no sense if you have to modify a lot of things....measure the motor length...motor diameter...shaft diameter (approximate)  and length.   If you are still not sure, send me a picture and I will try to help you
.