Flex Shot Rubber Adhesive Sealant Caulk, 8 oz, Black

Description

Caulks, bonds and seals virtually everything
Forms a watertight, flexible barrier that is easy to use
No running, dripping or mess
No caulking gun needed, just push the nozzle for a perfect bead every time
Perfect for sinks, tubs, windows, doors, and more
Flex shot
is a super thick rubber sealant that caulks, bonds, seals virtually everything. Flex Shot forms a watertight, flexible barrier and is so easy to use. No need for a bulky caulking gun, just push the nozzle for a perfect bead every time. No running or dripping and never shrinks or cracks. Flex Shot expands and contracts, fills in huge cracks and hole! Messy caulks dry out, but with Flex Shot, there is no waste, you can use it over and over again! Flex Shot won’t fade, dry, crack, yellow or deteriorate over time and last up to 30 years. It’s available in mildew-resistant white, almond, clear and black. Flex Shot is great for bathroom windows, tiles, showers, tubs, and toilet repairs. But it doesn’t stop there, use Flex Shot on all your arts and crafts, and decorative items. Flex Shot is the most easy to use adhesive sealant that provides a leak proof, strong bond seal! Caulk, Bond, and Seal!
Common Flex Shot Applications:
Bathroom showers, bathtubs, and toilet repairs, seal kitchen and bathroom sinks and faucets, replace worn out or missing tile caulking, fill large and small holes that cause leaks, seal and repair window and doorsills, crafts, and decorative items.
Recommended Surfaces:
Porcelain, tile, metal, glass, fiberglass, wood, granite, stone, marble, fabric, upholstery, paper, and just about any other surface that’s free of grease and oil.
Ingredients
Dimethylsiloxane (CAS No. 70131-67-8), Silica (CAS No. 7631-86-9), Methyltriacetoxysilane (CAS No. 4253-34-3), Ethyltriacetoxysilane (CAs No. 17689-77-9), Petroleum Distillates (CAS No. 64742-46-7), Difluoroethane (CAS No. 75-37-6), Polydimethylsiloxane (CAS No. 63148-62-9) and Carbon Black (CAS No. 1333-86-4).
Directions
Instructions:
Directions for Use: 1. All surfaces must be clean, dry and free from dirt, grease and oil. 2. Hold can at 45 degree angle, push against the nozzle side and apply into the joint or seam to obtain full contact between surfaces. 3. Flex Shot can be smoothed within 5 minutes of application. Remove excess immediately with a dry paper towel. 4. Sealant forms a tack free skin in 20 minutes. Length of full cure depends upon factors such as temperature and humidity, but sections up to 1/8 inch become rubbery solids in about 24 hours. 5. After using, extend a small amount of material beyond the end of the nozzle. This will cure and form a seal for the remaining material. Pull out this cured plug when you are ready to use again.